• Spacers for recoiler

    To make these particulars, we use steel with resistance to wear and to high toughness. We can make with different geometries and in case with chrome coating to accentuate this resistance.

    emmebi05

    Lightweight spacers

    They are made of nylon to withstand high temperatures, we can provide them with
    a crown made of steel or nylon only.

    emmebi06

    Rubberized spacer

    On our dpt. we make the rubber vulcanisation on tempered nucleus. The mixture use of high content of nitrile, it is sure for a max abrasion resistance. Colouring and hardness (from 65 to 90 Shore scale A) according to its use.

    emmebi07
    emmebi08

    Special rubbers spacers

    Made of hardened steel and then coated filimplastigom.

    emmebi09

    Acetate spacers

    We have ready in our stock a wide range of thicknesses that vary depending on the requirements from 0.05mm to 0.5mm, very useful for the composition of cutting widths with tolerances on the width or non-standard.

    emmebi10

    Slittin line spacers

    Made in steel with heat treatment final hardness 52÷56 HRc, we take care in the least particulars. The surface finish, only for thickness higher than 3 mm. for example, we make surface lapping, that is a guarantee for the highest precision of thickness, parallelism and flatness.

    emmebi11

    emmebi12